PDA

View Full Version : Custom Boat Parts



SteelyDon
07-13-2010, 05:51 PM
I work in a Sheet Metal/Machine Shop and have designed and fabricated consoles
and custom parts for small aluminum boats. Most have been for friends, however if
anyone needs custom boat parts they can post mark me to discuss any parts. I have access to CNC milling machines and punching machines.

SteelyDon

CRABBY
07-13-2010, 07:23 PM
Great to have a guy like you around,helpin out,wish we had a FAQ section I'd put you in there.Don

fishwishin
07-13-2010, 07:27 PM
Where are you located?
:cool:

bigeasy8240
07-14-2010, 09:43 AM
PM sent for a Jackplate and Kicker plate!

Gadabout
07-18-2010, 06:21 PM
I have a small NR and wanted a door placed over the opening that is on the pass side of the boat. PM me if you can do this job or if you have other thoughts.
thanks

SteelyDon
07-18-2010, 08:19 PM
I have a small NR and wanted a door placed over the opening that is on the pass side of the boat. PM me if you can do this job or if you have other thoughts.
thanks

I'm in the Roseville Area. As far as the door goes, I would have to have specific measurements. I have no problem holding tolerances of 1/64" to 1/32"

I guess I should have specified how to get info. It's best to email me a sketch/drawing until I get my fax hooked up (should have that up in a week). If you PM me it will com to my email and I can buzz ya.

Also if you are local to my area I could always meet somewhere.

Get back at me later. SD