
by Jack Naves
Spring is just around the corner, and stripers will soon be flooding into the California Delta in large numbers. During the spring run, stripers tend to be scattered out, so anchoring and soaking bait can be a hit or miss proposition. Trolling is the best way to cover water until you find the spots where pre-spawn stripers are holding. Before hitting the water this spring, let’s look at some advanced trolling techniques.
On February 8, I was lucky enough to be invited to fish on Jim Brittain’s boat. Jim is one of the best striper trollers on the delta, and he has a good network of anglers providing recent and accurate reports. Networking with other anglers is one of the best techniques you can use to put more stripers into your boat.
Knowing the latest trends and hotspots is something that the best guides and private anglers use to produce successful trips. Message boards, social media, and radio shows are a good starting point, but first-person reports are the best way to get directly onto the fish.
After launching at Brannon Island, Jim and I hit the ‘west bank’ area of the Sacramento River just below Rio Vista. Although we trolled in some of the spots Jim’s friends had recommended, we came up empty. We pulled lines and Jim shot us across the river to a new area where he advised that we switch over to deep diving plugs.
As I held my rod, I felt a sharp BANG. I slowly eased the rod tip forward, and then back towards the lure. BAM! The rod loaded up and started pumping in my hand. There’s one! I relayed to Jim as he worked the kicker motor. Once netted, we had our first keeper of the day in the boat. I used a rod-pumping technique to draw the strike.
Back when I first started trolling the delta, I fished out of my dad’s 13-foot aluminum boat. It had a 15-horsepower tiller-drive outboard. I had to manually throttle and